@air
2025-06-12

What is the average oil content of compressed air

The oil content in compressed air usually depends on the type and technical specifications of the air compressor. Generally speaking:

  1. Oil injection air compressor: During operation of this type of equipment, lubricating oil will participate in the compression process, so the oil content in the compressed air is relatively high, usually in the3ppm to 5ppmbetween.

  2. Oil-free air compressor: This type of equipment is specially designed to avoid direct contact between lubricating oil and compressed air, so the oil content in the compressed air is extremely low, usually lower than0.01ppm。

It should be noted that in practical applications, the oil content of compressed air may also be affected by factors such as equipment maintenance status and filtration system efficiency. In applications where higher air quality is needed, even if oil-free air compressors are used, additional filtering devices may be needed to further reduce the oil content.

Welcome!

Related Articles:
@air
2025-08-18

Industrial compressed air dust and oil pollution content

The compressed air quality of Granklin air compressor shows that Granklin air compressor adopts water-lubricated single screw compression technology to achieve gas compression through the precise cooperation of screws and star wheels. This design replaces traditional lubricating media with pure water to avoid…

@air
2025-12-23

Water content in outlet air of oil-free screw air compressor

The water content of the outlet air of an oil-free screw air compressor usually does not exceed 80ppm (the water content per cubic meter of gas does not exceed 80 mg). If post-treatment equipment such as a dryer is installed, the water content can be further reduced to below 5ppm, and the pressure dew point can reach-…

@air
2025-03-07

How to remove water in the air compressor

When the air inside the air compressor contains moisture, it can be removed by the following methods: 1. Physical drainage method Use drainage valve Installing a drainage valve at the bottom of the air compressor’s cooler or gas storage tank. Open the drain valve regularly to drain the moisture accumulated at the bottom of the […]

@air
2025-07-15

What air compressor is used in the chemical fiber industry

Application analysis of air compressors in the chemical fiber industry 1. Pressure grading requirements for the core demand of compressed air in the chemical fiber industry: Spinning process: 0.6-0.8MPa (6-8Bar) is needed to stabilize the air pressure to ensure uniform ejection of the melt. Drafting…

@air
2025-07-02

What is the role of air compressor draining water

Water release from air compressors is a key operation to ensure stable operation of equipment, improve production efficiency and ensure product quality. Its core role can be professionally analyzed from the following dimensions: 1. During the compression process of air at the equipment protection level, its internal moisture will be caused by…